mantaining wireless coverage with WCS

mirboukai · ‎06-16-2007

hi i have a wcs and how can i mantain

the wireless coverage through the wsc plan?(( i mean i dont want the wirless coverage to do out the building edge))

((i have put the plan and assigned the access point on them))

john.preves · ‎06-16-2007

perform a site survey and determine the location

of the AP's power settings and channel allocations.

After you have installed your system go back and manually configure each AP to the settings you determined during the survey, effectively turning auto RF off.

mirboukai · ‎06-17-2007

Hi

Thanks for your help...

But in this way I will re-assign the power and channel manually ... I though we could do it automatically by the WCS just telling him that we want no coverage out side the building edge

Rob Huffman · ‎06-18-2007

Hi Muzaffar,

John is on this case and knows from experience here (5 points for your good work John). This is a known issue, and I'm sure there is even an open Bug related to this, that I can't seem to find right now. Here is a recent thread that details many of these issues.

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Wireless%20-%20Mobility&topic=WLAN%20Radio%20Standards&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dde3ceb

It is sad but true, that DCA and RRM are not quite up to snuff yet :(

Rob