6509 Module Boot Device

Unanswered Question
Jun 16th, 2007
User Badges:

Hi, module 3 of one of our 6509s shows cf:4 as its boot location. This module had failed and had to be reloaded from cf:4 which is supposed to be the default application partition. The other 6509s that have not had a module failure this way has no entries in their boot order. This isn't a big deal, but I was wondering if there is a way to have cf:4 not show up on this switch. Just want to keep the configs the same.


Thanks.


Switch5#sh boot device

[mod:1 ]:

[mod:2 ]:

[mod:3 ]: cf:4

[mod:4 ]:

[mod:5 ]:

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
Loading.
b.hsu Fri, 06/22/2007 - 05:40
User Badges:
  • Silver, 250 points or more

For Catalyst operating system software, you can perform a full memory test when you enter the set boot device bootseq mod# mem-test-full command. This command is specific to Catalyst operating system software and is not available in Cisco IOS software.



http://www.cisco.com/en/US/products/sw/cscowork/ps5401/products_installation_and_configuration_guide_chapter09186a008073107e.html#wp1035560



Actions

This Discussion