Mobility Manager1.2 - dial delay by route point !#

Answered Question
Jun 16th, 2007
User Badges:

configured MM route point extension !# as per installation guide but it makes dial delay (15 sec inter-digt timeout) for all includes between IP phones. How can I resove this?


CCM5.0.4


Thanks in advance,

Correct Answer by Brandon Buffin about 9 years 11 months ago

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.


http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html


Hope this helps. If so, please rate the post.


Brandon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Brandon Buffin Sat, 06/16/2007 - 12:11
User Badges:
  • Purple, 4500 points or more

This route point should be in a special partition created for this purpose. The partition should only be accessible by the calling search space created for and assigned to the CTI ports for Mobility Manager. Sounds like you have the route point in a partition that is accessible by all phones. Take a look at the following doc.


http://www.cisco.com/en/US/products/ps6567/products_installation_guide_chapter09186a0080645bc0.html


Hope this helps. If so, please rate the post.


Brandon

Actions

This Discussion