dealing with switch 2900 IP addressing

Unanswered Question
Jun 17th, 2007
User Badges:

the problem is that I have a switch 2900 xl seires and I can not make a telnet to it

in my network the management vlan is vlan no 6 so i had to assign ip address to the interface vlan 6 on that switch

I did that but it remained shut down despite being manually configured to be up

when I use interface vlan 1 it responded but the telnet yet didn't work

i need a suggestion

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rajinikanth Sun, 06/17/2007 - 22:46
User Badges:
  • Bronze, 100 points or more

Hi,


Have you configured your VTY lines with password and login commands.


VTY LINES are needed to be configured for telnet connection


HTH


Raj

wamohamed Sun, 06/17/2007 - 22:56
User Badges:

Hi Raj,


yes ofcourse i configured vty lines and set the password but the problem still exists


i think that the problem is related to the fact that i set interface vlan 1 as the management interface whereas it should be interface vlan 6 which i can not configure on that switch

mohammedmahmoud Sun, 06/17/2007 - 23:18
User Badges:
  • Green, 3000 points or more

Hi,


You must be connected to the switch on a port in VLAN6.



HTH,

Mohammed Mahmoud.

glen.grant Mon, 06/18/2007 - 04:19
User Badges:
  • Purple, 4500 points or more

If you have a management vlan and also have other different vlans assigned to this switch your uplink has to be a trunk link in order to do this . Also the 2900 has to be a newer 8 meg box versus the old 4 meg 2924's which would not support trunking.

Actions

This Discussion