06-18-2007 06:16 AM - edited 03-14-2019 10:08 PM
Hi all,
voice-port 0/2/0
!
voice-port 0/2/1
!
ccm-manager mgcp
!
mgcp
mgcp call-agent 10.3.1.196 service-type mgcp version 0.1
mgcp dtmf-relay voip codec all mode out-of-band
mgcp validate domain-name
!
mgcp profile default
!
dial-peer voice 100 voip
destination-pattern ....
session target ipv4:10.3.1.196
!
dial-peer voice 1000 pots
service mgcpapp
port 0/2/0
Above is my configuration of mgcp gateway with VIC2-2FXO... its registered with CCM and was working fine...all of a sudden it stopped working.... when I dial on the number terminated on FXO, call dont go through.... I have attached a file with sh ccm-manager and debug mgcp events output.... Any help ??
Thanks
Sheeraz
06-22-2007 06:15 AM
What version of CCM are you using ?
06-22-2007 10:03 PM
CCM 4.1(2)...and the voice gateway is 2811.
Here is the show version as well .
KHI-FTC-RO-I-A8M1-02#sh ver
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.3(14)T
7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 22-Mar-06 18:40 by pwade
ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)
KHI-FTC-RO-I-A8M1-02 uptime is 3 days, 17 hours, 10 minutes
System returned to ROM by power-on
System restarted at 17:53:53 GMT Tue Jun 19 2007
System image file is "flash:c2800nm-adventerprisek9-mz.123-14.T7.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
Cisco 2811 (revision 53.51) with 247808K/14336K bytes of memory.
Processor board ID FHK0918F098
2 FastEthernet interfaces
62 Serial interfaces
2 Channelized E1/PRI ports
1 Virtual Private Network (VPN) Module
4 Voice FXO interfaces
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62592K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
KHI-FTC-RO-I-A8M1-02#
Any suggestion.Thanx in advance
Sheeraz
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: