06-18-2007 08:38 AM - edited 03-11-2019 03:31 AM
I recently migrated our firewall from pix 6.3 to asa 5510. After the migration only the users having ip address 10.100.0.x can connect to the internet except the others having the IP address 10.100.1.x and 10.100.2.x. Everything else works fine as before. I copied most of the config including nat and accesslist from the previous config. What could be possible causes of this problem?
06-18-2007 09:02 AM
Could you post a clean config? Possible cause could be a /24 mask instead of /16 mask in your nat statement etc.
06-18-2007 09:16 AM
You may also need a route inside for the .1 and .2 networks?
06-18-2007 11:57 AM
Thanks all for the response. I found that net mask for inside interface was set up as 255.255.255.0 (/24) All of the internal servers have ip address 10.100.0.x/16. Most of the clients get ip addresses 10.100.1.x/16 from dhcp server.
Do you think netmask /24 for inside interface is the problem.
06-19-2007 08:00 AM
That would do it, change the mask on the firewall interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide