Bridging(1300 series)

Unanswered Question
Jun 18th, 2007

Hi I'm Serge and i configured 2 Cisco 1300 series bridges for Point 2 Point connectivity.

The lattency on the link has an average of 3 ms.

Signal strength of:77 dbm

the connectivity fro both side is good as ping test.

But when i put some data in trasnfer it take too much time.

i trasferd a file of 16.5 MB in about 7 mn.

pls help me find a solution about that radio link asap.

thx!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bwalchez Fri, 06/22/2007 - 09:50

Make sure the bridge is configured for Maximum Throughput whcih enables bridge to work at optimum speed.

carlosmadriz Thu, 09/25/2008 - 13:54

Hi, did you manage to resolve the latency problem? I'm having exactly the same issue here.

Sergent_02 Fri, 09/26/2008 - 02:27

I had a lot of Interferance @ the site and pls make sure the transfer rate is on default for better throughput if u have some kinda interferance. Thx

Sergent_02

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode