06-18-2007 09:59 AM - edited 07-03-2021 02:13 PM
Hi I'm Serge and i configured 2 Cisco 1300 series bridges for Point 2 Point connectivity.
The lattency on the link has an average of 3 ms.
Signal strength of:77 dbm
the connectivity fro both side is good as ping test.
But when i put some data in trasnfer it take too much time.
i trasferd a file of 16.5 MB in about 7 mn.
pls help me find a solution about that radio link asap.
thx!
06-22-2007 09:50 AM
Make sure the bridge is configured for Maximum Throughput whcih enables bridge to work at optimum speed.
06-26-2007 08:26 AM
Can you post your configs?
Seth
09-25-2008 01:54 PM
Hi, did you manage to resolve the latency problem? I'm having exactly the same issue here.
09-26-2008 02:27 AM
I had a lot of Interferance @ the site and pls make sure the transfer rate is on default for better throughput if u have some kinda interferance. Thx
Sergent_02
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide