cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
409
Views
0
Helpful
4
Replies

Bridging(1300 series)

Sergent_02
Level 1
Level 1

Hi I'm Serge and i configured 2 Cisco 1300 series bridges for Point 2 Point connectivity.

The lattency on the link has an average of 3 ms.

Signal strength of:77 dbm

the connectivity fro both side is good as ping test.

But when i put some data in trasnfer it take too much time.

i trasferd a file of 16.5 MB in about 7 mn.

pls help me find a solution about that radio link asap.

thx!

4 Replies 4

bwalchez
Level 4
Level 4

Make sure the bridge is configured for Maximum Throughput whcih enables bridge to work at optimum speed.

srosenthal
Level 4
Level 4

Can you post your configs?

Seth

Hi, did you manage to resolve the latency problem? I'm having exactly the same issue here.

I had a lot of Interferance @ the site and pls make sure the transfer rate is on default for better throughput if u have some kinda interferance. Thx

Sergent_02

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: