How do i measure packet loss on a point to point ethernet wan link using cisco routers?
Does it depend on the datagram size?
HI, [Pls Rate if Helps]
Thanks for Posting the Configuration.
I see in R2 FEth 1.50 you have 3-IP's assigned. 1-Primary & 2-Secondary IP.
Since R1----R2 are directly connected. I hope the error is with IP Assignments.
Required, a Static Route from R1----R2 for the same Subnet "255.255.255.252" . Since the IP's assigned (Pri & Sec) to FastEth1.50 is in different Subnet the R1 is taking time for locating the correct IP Subnet.
Else, do a Test by removing all the Sec..IP & assign "255.255.255.252" Subnet as Pri..IP for the Sub-Interface FEth 1.50
Also, in R1 under FEth0 set the "encapsulation to dot1Q 50"
Hope this Helps you. Pls Rate if Helps
Guru Prasad R