cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
361
Views
9
Helpful
4
Replies

Service Manager wont start

kevinhobson2000
Level 1
Level 1

Hi,

I have setup a callmanager 5.0 test box and the Service Manager wont start. I have tried restarting it using the relevent cli command to no avail.

Any help would be appreciated.

Regards

Kev

4 Replies 4

mchandak
Level 7
Level 7

Hi,

Have you installed CM 5.x license on the box. The CM services cannot be started until and unless Node license file has been installed on the box. Incase you have not got the license file yet, email the PAK number along with MAC Address of your box to licensing@cisco.com to get the license generated and emailed to you

Hi,

Thanks for the reply i was thinking that was why.

Is it possible to get an evaluation license?

As this is only a test box for CCVP purposes.

Cheers

Kev

I dont think so. You will have to check with your Cisco Rep/Reseller and see if they are aware of any such copy being available. AFAIK, there is no such option available for CM 5.x

Ok thanks for your help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: