Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
314
Views
0
Helpful
1
Replies

cli command to check CCM 5.x DHCP configuration

ciscoforum
Level 1
Level 1

‎06-20-2007 11:57 AM - edited ‎03-14-2019 10:11 PM

Here is the steps I got from Cisco link regarding to enable DHCP on CCM 5.x

My question what the cli command to check the dhcpd.conf on step 4. Thanks

-------------------------------------

DHCP Server Configuration Process

Use the following steps to configure DHCP Process:

1. Enable the DHCP functionality from the serviceability window.

2. Verify the DHCP monitor process is started on the node where the DHCP is enabled.

3. Use Cisco Unified CallManager Administration to configure the scopes and options.

4. Verify that configuration is captured in the /etc/dhcpd.conf file of targeted Cisco Unified CallManager.

5. Verify the DHCP server daemon is running with new configuration.

6. Make sure DHCP monitor process logs at the specific trace settings.

7. Make sure the error alarm is raised when the DHCP daemon is stopped and the info alarm is raised when the daemon is restarted.

Labels:
0 Helpful
1 Reply 1

s.jankowski
Level 4
Level 4

‎06-26-2007 10:22 AM

It's the dhcp daemon configuration file of the linux operating system. The file is read every time when the daemon is restarted

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents