Async Line Configuration

Unanswered Question
Jun 21st, 2007
User Badges:

Hi

i am working with 1841 with WIC-2A/s . created Async lines. when i try to telnet to Async lines its connecting. i am able to communicate for very short period after some time communication is going down if i type alphabets of 26 i am able to get only 10 out of it here i am attaching the configuration. plz tell me how to resolve this error.

Hyper terminal side : 9600/8/1/non/Hardware flow control


remote telnet : 192.168.1.202 2018




Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
guruprasadr Thu, 06/21/2007 - 01:51
User Badges:
  • Gold, 750 points or more

HI,


Hope this Link will help you to Solve.


http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1831/products_command_reference_chapter09186a0080087e18.html#1018303


INFO: Cisco IOS support multi-protocol packet assembler/disassembler (PAD)

services to allow asynchronous terminals to connect to hosts via the X.25 protocol.

PAD services are enabled by default on cisco routers. Disable the service unless

absolutely needed.



PLS Rate if HELPS


Best Regards,


Guru Prasad R

rsjavahar Thu, 06/21/2007 - 03:23
User Badges:

no this is not the solutions. what i am looking



thank you for your advise

Javahar

Actions

This Discussion