06-21-2007 12:59 AM - edited 03-05-2019 04:52 PM
Hi
i am working with 1841 with WIC-2A/s . created Async lines. when i try to telnet to Async lines its connecting. i am able to communicate for very short period after some time communication is going down if i type alphabets of 26 i am able to get only 10 out of it here i am attaching the configuration. plz tell me how to resolve this error.
Hyper terminal side : 9600/8/1/non/Hardware flow control
remote telnet : 192.168.1.202 2018
06-21-2007 01:51 AM
HI,
Hope this Link will help you to Solve.
INFO: Cisco IOS support multi-protocol packet assembler/disassembler (PAD)
services to allow asynchronous terminals to connect to hosts via the X.25 protocol.
PAD services are enabled by default on cisco routers. Disable the service unless
absolutely needed.
PLS Rate if HELPS
Best Regards,
Guru Prasad R
06-21-2007 03:23 AM
no this is not the solutions. what i am looking
thank you for your advise
Javahar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide