06-21-2007 04:52 AM - edited 07-03-2021 02:14 PM
Hi all,
I am trying to set up radius authentication for the management users of WCS. I am using freeradius.
I created a user and set included the necessary group tasks in the reply using Cisco-AVPair. I can see in the debug on the radius server that the user is indeed authenticated and the Cisco-AVPair values are returned in the authentication response, however WCS reports that the user could not be logged in due to an invalid password.
In the meantime, I have reverted to using local users.
Has anyone set up WCS against freeradius for authentication of the management users?
Thanks
06-28-2007 05:14 AM
Try to remove and reconfigure WCS and then restart the WCS.
06-28-2007 07:56 AM
what does freeradius indicate?
kill your freeradius daemon and run freedadius in debug mode as root
#radiusd -XA
watch the output on your freeradius server while
you try to authenticate to WCS.
it should give some clues as to why it is failing. my guess would be the ports radius is config'd for.
11-08-2010 07:47 PM
I have this issue as well. I am using Cisco ACS for Radius and it fails on both IETF and Cisco Radius.
I have the attributes and it says invalid password although my authentication has passed correctly.
Has anyone got this working?
Thanks
Brad
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide