06-21-2007 05:46 AM - edited 03-03-2019 05:32 PM
configure nat for interface 0/1
i have 2 wans i want configure nat on interface 0/1 and test it with computer connected to 0/1/2(i configured 10.0.0.2 and working dns on the computer interface) my interface address is 192.168.xx.xx 255.255.255.252(configured by internet supplier) and my legal ip address
(by internet supplier) is 213.31.xx.xx subnet 255.255.255.248
i want to give hosts subnet 10.0.0.0
interface 0/0 connected to switch and active i cant touch it
the router is 1841
thanks in advance
b555
interface FastEthernet0/0
description Line To Bez
ip address 10.20.xxx.xxx 255.255.255.252
ip nbar protocol-discovery
speed 100
full-duplex
!
interface FastEthernet0/1
description Line To Info
ip address 192.168.x.x 255.255.255.252(configured by supplier)
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1/0
description Connected to LAN
!
interface FastEthernet0/1/1
!
interface FastEthernet0/1/2
switchport access vlan 3
!
interface FastEthernet0/1/3
description trunk
switchport mode trunk
shutdown
!
interface Vlan1
description Line To LAN
ip address 212.179.xxx.xx 255.255.255.248
!
interface Vlan2
description infonetLegalToLan (not active just for try)
no ip address
!
interface Vlan3
description infonet
ip address 10.0.0.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
ip classless
ip route 0.0.0.0 0.0.0.0 10.20.xxx.xxx for first interface
ip route 0.0.0.0 0.0.0.0 192.168.x.x for second interface
!
!
no ip http server
ip http authentication local
ip http secure-server
ip nat pool overinfoToUsers 213.31.xx.x 213.31.xx.x netmask 255.255.255.248
ip nat inside source list 7 pool overinfoToUsers overload
!
ip access-list standard test
!
access-list 1 permit any
access-list 7 permit 10.0.0.0 0.0.0.255
access-list 18 remark Remote Management
06-22-2007 02:54 AM
Hi ,
Create an access-list 7 as below
after that go to int f0/0 and configure the command ip nat inside..
access-list 7 permit 10.20.0.0 0.0.0.3.
int f0/0
ip nat inside
Thanks,
Satish.
06-22-2007 12:35 PM
hi, but i want to nat wan interface 0/1
(wan 0/0 is active now connected to a cheap temporery router thats why i am making tests on interface 0/1 and 10.0.0.0 i want to send the internal computers )
the completed configuration i want 2 valns one for wan 0/0 and for 0/1
thanks in advance
b555
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: