asa5505 and 8.02 issue

Unanswered Question
Jun 21st, 2007
User Badges:

This is the error I get when I try and set the 8.02 image as the boot image. Any suggestions?

[OK] asdm image disk0:/asdm-602.bin

[ERROR] boot config disk0:/asa802-k8.bin

Unable to set this url, file has non-ASCII characters

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jaffer_sathik2010 Thu, 06/21/2007 - 07:19
User Badges:

Do you have two images now in the ASA box? if yes, remove the old one(take back-up) and place the only image which you want to use.

Did you get the same problem with the 602 image also? if yes , check whether 'disk0'

is fixed properly in the hardware.

Let me know the status


sos Thu, 06/21/2007 - 07:25
User Badges:

Ok, this is what Tac had to say:

The problem is the command you are using, instead of using

boot config disk0:/asa802-k8.bin the correct command is:

boot system disk0:/asa802-k8.bin

Funny thing was I was using the ADSM upgrade tool and not the CLI, so I issued the CLI commands and it worked just fine.


This Discussion