Deciphering boot message: % ATM1/0 :ILMI disabling...

Unanswered Question
Jun 21st, 2007

I have a customer who is bothered by the boot up message "% ATM1/0 :ILMI disabling will take effect in the next interface restart" that appears on our standby 3845 whenever it is cold booted.

I have been unable to explain it to him in terms that will allay his fears.

How is the best way to describe this message?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
a-vazquez Wed, 06/27/2007 - 10:20

To enable autoconfiguration on an interface, perform the following steps, beginning in global configuration mode:

Step Command Purpose

1 interface atm card/subcard/port[.vpt#]

2 atm auto-configuration

Enables autoconfiguration on the interface

To confirm that autoconfiguration is disabled for the interface, use the following EXEC command:

show atm interface atm card/subcard/port

Actions

This Discussion