06-21-2007 11:24 AM - edited 03-05-2019 04:53 PM
Hello!
Network Design and Config
*************************
part of the Project Like This:SW1(VLAN100) connected to DS1
SwitchB(Vlan200)Connected to DS2;SW1 HAS Stack Link to SW2.DS1 Has L2 Link to DS2
i will setup 2 DSs and 20 vlans and Run HSRP Between it because the 2 6509 sup 1 doesn't support GLBP so plz examine my Config:
DS1
****
STP vlan 100 priority 4096
STP vlan 200 priority 8192
DS2
***
STP vlan 200 priority 4096
STP vlan 100 priority 8192
Now for HSRP
DS1
***
int vlan 100
ip address 100.x.100.3/24
standby 20 ip 100.200.100.1
standby 20 priority 110
standby 20 preempt
int vlan 200
ip address 100.x.200.3/24
standby 21ip 100.200.200.1
DS2
***
int vlan 200
ip address 100.x.200.3/24
standby 21ip 100.200.200.1
standby 21 priority 110
standby 21 preempt
int vlan 100
ip address 100.x.100.2/24
standby 20 ip 100.200.100.1
Now:what is ur Greatfull Comments to this Design/config
10xs
Ali
10xs
06-21-2007 11:49 AM
Very straightforward and I see no problems. Good luck !
06-22-2007 09:11 AM
Hello Experts!
Ok,let Say we want to move to GLBP Does this Config Works or must config on the DSs stp side Like this:
DS1
***
Root bridge primary
DS2
***
Root bridge Secondary
than the GLBP Load Balence across all vlans
any great Coments
Ali
06-22-2007 10:32 AM
Leave the STP setup as before, since it's layer 2 share. GLBP will load balance at L3.
06-27-2007 11:09 AM
Hello Again!
what if EACH Switch has 2 direct connection to each Distribution(DS1 & DS2).what would be the config of the STP? Shall i keep it the Same?
10xs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide