Cisco Secure Service Client and CTA - Wireless NAC support

Unanswered Question


I'm deploying NAC framework via wireless with NAC L2 802.1x. The authentication is set to PEAP. It work fine but when I enable the posture validation check the connection fail.

I'm using the following software version:

Access Point: AIR-AP1131AG-A-K9 - 12.3(8) JA2

CSSC (Cisco Secure Service Client): 4.1.2

CTA: 2.1. I use "CtaAdminEx-win-" file

ACS: 4.0

In the client PC (on the task bar) I only see the CSSC icon, I'm not see the CTA icon. If I go to Administrative tools --> Services the "Cisco Systems, Inc. CTA Posture State Daemon" is started.

It seems that posture validation is not performed because communication between CTA and CSSC is not working.

Must I configure anything to establish communication between CTA and CSSC?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion