Checking an over utilised serial sub interface

Unanswered Question
Jun 22nd, 2007
User Badges:

Hello If I have sub interface s0/2.23 how can I see on the actual interface how much traffic is running over.


I asked this question relating to graphing the interface and got excellent response.


However, checking the interface itself without graphing it, how will I determine how much traffic is running over this interface


thank you

wvw

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
guruprasadr Fri, 06/22/2007 - 01:36
User Badges:
  • Gold, 750 points or more

HI, [Pls Rate if Helps]


You have to verify the below Information in the Show Output of Serial Interface.


INCHER01>show int se 0/2.23

Serial1/0 is up, line protocol is up


reliability 255/255, txload 43/255, rxload 57/255


5 minute input rate 10038000 bits/sec, 2227 packets/sec


5 minute output rate 7534000 bits/sec, 2095 packets/sec


722906785 packets input,

Received 76836 broadcasts,



INCHER01>show int serial 0/2.23 stats


========>This Command will give the Statistics of entire Serial Interface Traffic



PLS RATE if HELPS


Best Regards,


Guru Prasad R

griffinmark Fri, 06/22/2007 - 02:04
User Badges:

To get a more accurate snap shot you can use the load-interval 30 command under the interface to drop the interval from 5 mins to 30 secs. This will help track the spikes in utilization a little better. The other nice thing about this command is it applies to show policy map interface outputs too.


In my opinion 30 secs isn't that create either so a lot of times I will use the SDM to look at utilization in 10 sec intervals if I think traffic is bursting up to the ceiling.


On a side note, I'm amazed at what the SDM can do, it 's almost good enough to but us engineers out of a job.

willemvwyk Mon, 06/25/2007 - 00:09
User Badges:

Hi I think I am running an older IOS as I don't have the command :(


Mainrouter1#sh int s0/1.39 ?

description Show interface description

precedence Show interface precedence accounting info

rate-limit Show interface rate-limit info

| Output modifiers


Mainrouter1#sh int s0/1.39

Actions

This Discussion