06-22-2007 04:44 AM - edited 03-03-2019 05:33 PM
hi,
i have a 7604 router with som gig interfaces.
i have some subinterfaces (802.1q) interfaces on the physical interface, which are trunks to other mpls pe router, so i have to do labelswitching.
therefore i use the command "mpls mtu 1512".
the problem is, that i only can configure this command on the physical interface and NOT on the subinterface.
or is it so, that if i configure this on the main/physical interface that automaticly this is also so for the subinterfaces??
!
!
interface GigabitEthernet4/0/1
description MPLSRBGOPE02: phy.Link to MPLSRBGOSwi02 (Gi4/0/1-Trunk)
no ip address
load-interval 30
shutdown
negotiation auto
mpls mtu 1512
!
!
interface GigabitEthernet4/0/1.190
mplsrbgope02-test-76(config)#interface GigabitEthernet4/0/1.190
mplsrbgope02-test-76(config-subif)#mpls mtu ?
<64-1500> MTU (bytes)
mplsrbgope02-test-76(config-subif)#mpls mtu 1512
^
% Invalid input detected at '^' marker.
mplsrbgope02-test-76(config-subif)#
06-22-2007 11:22 AM
correct...it is supported on physical interfaces.
06-25-2007 01:10 AM
hi,
thanks for answer -
... andi it does mean that it is automaticlly
active on the eth subinterfaces ???
(mpls mtu 1512)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: