cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
795
Views
0
Helpful
2
Replies

mpls mtu command on subinterfaces

rabeder
Level 1
Level 1

hi,

i have a 7604 router with som gig interfaces.

i have some subinterfaces (802.1q) interfaces on the physical interface, which are trunks to other mpls pe router, so i have to do labelswitching.

therefore i use the command "mpls mtu 1512".

the problem is, that i only can configure this command on the physical interface and NOT on the subinterface.

or is it so, that if i configure this on the main/physical interface that automaticly this is also so for the subinterfaces??

!

!

interface GigabitEthernet4/0/1

description MPLSRBGOPE02: phy.Link to MPLSRBGOSwi02 (Gi4/0/1-Trunk)

no ip address

load-interval 30

shutdown

negotiation auto

mpls mtu 1512

!

!

interface GigabitEthernet4/0/1.190

mplsrbgope02-test-76(config)#interface GigabitEthernet4/0/1.190

mplsrbgope02-test-76(config-subif)#mpls mtu ?

<64-1500> MTU (bytes)

mplsrbgope02-test-76(config-subif)#mpls mtu 1512

^

% Invalid input detected at '^' marker.

mplsrbgope02-test-76(config-subif)#

2 Replies 2

deveshkumar
Level 1
Level 1

correct...it is supported on physical interfaces.

hi,

thanks for answer -

... andi it does mean that it is automaticlly

active on the eth subinterfaces ???

(mpls mtu 1512)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: