We have decided to run the central firewall for our customers using VRF. So below I have posted the VRF config for one company, this config is on our PPPoE Router.
Our PPPoE Router is connected to an Cisco ASA 5540, and the ASA nat`s the customers to the internet.
ip vrf Company1
route-target export 65520:1400
route-target import 65520:1400
encapsulation dot1Q 210
ip vrf forwarding Company1
ip address 192.168.5.10 255.255.255.0 secondary
ip address 10.16.1.40 255.255.255.248
no snmp trap link-status
address-family ipv4 vrf Company1
ip route vrf Company1 0.0.0.0 0.0.0.0 10.16.1.41
ip route vrf Company1 192.168.5.10 255.255.255.128 10.18.2.1
So the question now is :
1. is this configuration correct on the PPPoE Router ?? something I missed ??
2. now the question is, which parameters I need to configure in the radius server so the customers Router-Modem can receive it after he connect it to the pppoe router, usually the RADIUS gives the ip address to the customer, but in this case there is more info that RADIUS needs to assign to the customers router such as VRF info. So could someone please explain this to me ?? some example too ?
Thank You !!