Problem with multicast music-on-hold

Unanswered Question

I am experiencing a problem with my multicast music-on-hold streams. It seems that all streams are sent to my branches and I am not sure why.

I am running sparse-dense pim.

I look in the IGMP group memberships and none of my moh streams are registered.

So I assume that the routers themselves must be notifying the DR that they want the MOH streams.

So I can tell and how can I prevent the routers from requesting unneeded streams?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
gogasca Sat, 06/23/2007 - 19:06

In CCM you may configure the MAX HOPS for MMOH in MOH server configuration.

Or create an ACL and multicast boundary in your WAN interfaces.

The following is an example configuration:

Router(config)# interface serial 0/0

Router(config-if)# ip multicast boundary 1

Router(config-if)# exit

Router(config)# access-list 1 deny 239.1.1.1

http://www.cisco.com/univercd/cc/td/doc/product/access/ip_ph/srs/srsinter/moh.htm#wp1118060

dgahm Sun, 06/24/2007 - 09:01

Brian,

Does a show ip mroute count confirm that the multicast streams are being forwarded by the routers?

I have never seen this happen with sparse mode PIM, so unless you really need sparse-dense this might be another solution in addition to those suggested by Gonzalo.

Here is a good document for troubleshooting multicast issues:

http://www.cisco.com/en/US/tech/tk828/technologies_tech_note09186a0080093f21.shtml

Please rate helpful posts.

Dave

Actions

This Discussion