06-23-2007 09:00 AM - edited 03-05-2019 04:55 PM
I'm Chinese, there is a problem with my work,thank you all first!
########################################
the enviroment:
UNKNOWN line card: ws-x6148a-ge-tx
Cisco Catalyst 6506 with super engin 2
Old IOS 12.1 (Running IOS)
new IOS s222-ipservicesk9_wan-12.2-18.sxf6.bin (prepare to Upgrade)
PCMCIA Flash card 64M (new ios is 50M, placed here)
sup-bootflash:64M running ios is placed here
config-register 0x2102
bootvar:
boot system disk0:
boot system disk0:s222-ipservices.....
boot system flash disk0:s222...
boot system flash sup-bootflash:c6k...(Running IOS)
rommon 1> dev
..... pcmcia ... slot0(disk0: was shown in ios, slot0 here in Rommon??)
#########################################
with the configuration was shown,the switch was able to start with disk0,just as the PCMCIA card was not in ! it start with sup-bootflash everytime!
help me , i was so worry about that i did't eat anything all the day..
My English is not very good,if the situation i had shown is not very clearly, pls tell me ,
my msn is love.leo@msn.com
06-23-2007 09:29 AM
the key is that how does the switch can boot from the disk0, i think
06-28-2007 09:22 AM
The problem has been Fixed!!
the key is that my Rommon version is 6.1, but the ata flash card need the Rommon version up that 7.1 on super engin 2
when i had upgrade the Rommon version to 7.1,the ata flash card has been read sucessfully !!!
and than the sw start form the disk0: loading the new ios .
V
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: