Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
345
Views
0
Helpful
4
Replies

load sharing after 50% utilization of primary link

zahid77
Level 1
Level 1

‎06-24-2007 08:56 PM - edited ‎03-03-2019 05:35 PM

ihave 2811 with 2 lease lines connected to service provider. i want to utilze both link but 2nd link will be utilzed once primary link would be utilized more then 50%. any solution available other then multi linking

Regards

Zahid Fayaz

Labels:
0 Helpful
4 Replies 4

ack_cisco
Level 1
Level 1

‎06-24-2007 09:38 PM

Hai,

I am also expecting solution for same senario..

Regards

A.ChenthilKumar

0 Helpful

Pavel Bykov
Level 5
Level 5

‎06-25-2007 12:14 AM

What routing protocol are you using?

You can probably achieve this by manipulating routing protocol.

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame

‎06-25-2007 12:47 AM

In short, is not possible.

Cisco has intreoduce sometingh called OER, but is new and may not be right for any situation.

You can also try some config with IP SLA and tracking, but once again it does not seem to be a best practice.

0 Helpful

ack_cisco
Level 1
Level 1
In response to paolo bevilacqua

‎06-26-2007 06:11 AM

hai,

Ok fine and Thanks

If you find any option in nearby timing you can inform me..

Regards

A.ChenthilKumar

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card