cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
800
Views
10
Helpful
5
Replies

Upgrade IOS.

ciscokalpesh
Level 1
Level 1

Hi,

I have below Switches and want to upgrade the software in all.

Device: WS-C2950SX-24

Software Version: 12.1(11)EA1-C2950-16Q4L2-M

Device: WS-2950G-48-EI

Software Version: 12.1(13)EA1-C2950-16Q4L2-M

Device: WS-2950T-24

Software Version: 12.0(5.3)WC(1)-C2950-C3H2S-M

I downloaded the below file

C2950 EI & SI IOS Image & Web Based Device Manager

c2950-i6q4l2-tar.121-22.EA10.tar

Can i use this image for upgrade in all the above mentioned switches ?

Please guide.

Thanks

2 Accepted Solutions

Accepted Solutions

mrmozaffari
Level 1
Level 1

Hi

yes ,but then you need to extract the ios because it is (tar).

Regards B.mozaffari

Please rate if helpful.

View solution in original post

Hi,

Totally agree with Narayan, and please note that, images that begin with c2950-i6q4l2 have both SI and EI feature sets integrated. The model of 2950 that you use determines the feature set that gets activated. When downloaded, the image recognizes the hardware and enables the appropriate set of features.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a0080169627.shtml

HTH,

Mohammed Mahmoud.

View solution in original post

5 Replies 5

mrmozaffari
Level 1
Level 1

Hi

yes ,but then you need to extract the ios because it is (tar).

Regards B.mozaffari

Please rate if helpful.

royalblues
Level 10
Level 10

yes you can.

Make sure you have sufficient Flash and RAM memory available

Narayan

Hi,

Totally agree with Narayan, and please note that, images that begin with c2950-i6q4l2 have both SI and EI feature sets integrated. The model of 2950 that you use determines the feature set that gets activated. When downloaded, the image recognizes the hardware and enables the appropriate set of features.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a0080169627.shtml

HTH,

Mohammed Mahmoud.

farkascsgy
Level 4
Level 4

Hello,

Use archive download-sw command and you don't need extract the tar file, it will automatically extract and set the boot system parameters...

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_14_ea1/command/reference/cli1.html#wpmkr3052364

bye

FCS

Please rate me if I helped.

Thanks all for replying.

Kalpesh.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco