Cisco 3550 Vlan Traffic Shaping

Unanswered Question
Jun 25th, 2007
User Badges:

I would like to build a very simple network with a switch divided up into 4 vlan's and a single uplink to a firewall. I would like to assign bandwidth to each of these vlan's. What is the best approach to take for this?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Pavel Bykov Mon, 06/25/2007 - 03:04
User Badges:
  • Silver, 250 points or more

If you are trying to control bandwidth from VLANs to Firewall, than you can use policing on each VLAN or policing/shaping on output interface to firewall. You would have to classify traffic based on source address.

criss_noh Mon, 06/25/2007 - 23:25
User Badges:

i will teach you very simple command.

just enter vlan interface and command

traffic-shaping average xxxx


This Discussion