Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
931
Views
0
Helpful
1
Replies

Port Forwarding in Cisco 2821 & Pix 525

soshomile
Level 1
Level 1

‎06-25-2007 02:43 AM - edited ‎03-03-2019 05:35 PM

Dear All;

i need to configure port 3389 (RDP) Port. i have three Layer 3 devices. Cisco 2800 connected to I.net the Pix 5xx then again Cisco 2800. NAT is already configure in PIX525. Port forwarding command is

#)IP NAT inside source static tcp 192.168.x.x 3389 58.77.x.x 3389 extandable

should i pass this command in first router or in PIX or router behind firewall..?

Labels:
0 Helpful
1 Reply 1

aghaznavi
Level 5
Level 5

‎06-29-2007 05:52 AM

You need to do it in the firewall as it's facing the internet

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card