Bandwidth command on physical or sub-interface?

Answered Question
Jun 25th, 2007

Hi All,

I am just going through finishing some study but wondering about where the bandwidth command ** should ** be placed?

Should it be specified on the physical interface or sub-interface for routing protocols to calculate the correct metric?

Cheers

I have this problem too.
0 votes
Correct Answer by Edison Ortiz about 9 years 5 months ago

Routing protocols run under interfaces with an IP assigned. If the sub-interfaces have the IP, then the bandwidth statement should be there.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
Correct Answer
Edison Ortiz Mon, 06/25/2007 - 18:42

Routing protocols run under interfaces with an IP assigned. If the sub-interfaces have the IP, then the bandwidth statement should be there.

cameron.moody Mon, 06/25/2007 - 19:22

Thanks EdisonOrtiz

Thats what I thought the answer would be but was 100% sure of it.

Cheers

Cameron

Actions

This Discussion