Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
780
Views
7
Helpful
4
Replies

login banner does not appear on ASA 5540 with ssh version 2 enabled

jgtheodor
Level 1
Level 1

‎06-25-2007 11:17 PM - edited ‎03-11-2019 03:35 AM

Hi, recently i connected in the network a failover system ASA 5540 [Version 7.2(2)] (active/standby). I have added the command login banner and I had already enabled ssh version 2. Unfortunately when i make an ssh session to ASAs the banner does not appear. Does anybody know why this happen? Thanks for any help!

Labels:
0 Helpful
4 Replies 4

jgtheodor
Level 1
Level 1

‎06-29-2007 01:59 AM

Hi again,

Does anybody know this issue....urgent

Thanks in advance!

0 Helpful

JBDanford2002
Level 1
Level 1
In response to jgtheodor

‎06-29-2007 03:33 AM

Sorry for the short response. Use "banner motd" instead.

switchtower
Level 1
Level 1
In response to JBDanford2002

‎07-15-2009 10:03 AM

they were looking for a login banner. The motd doesn't show up until after one logs in.

Why isn't this supported for SSH?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card