SDM is not showing SERIAL interfaces in itself

Unanswered Question
Jun 26th, 2007

Hi guys,

I am using SDM for checking the CPU utilization and Memory usage.

But when i check the INTERFACE STATUS in MONITOR mode, Only GigabitEthernet interface is showing with its bandwidth utilisation not any Serial Interface is displaying.

I want that Serial Interface connected to my Router with Multilink interface will display.

Any suggestion.

Sunny Rathore

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Tue, 06/26/2007 - 07:58

Hello,

SDM has serious limitations in doing many things and quite possibly this is one of them (multilink).

For professional configuration and monitoring of cisco devices, please use CLI and traditional SNMP tools.

pclark Wed, 11/14/2007 - 12:35

Anyone find a fix for this? I have the same issue with SDM 2.4.1 on a 2800 series router.

SDM sees the serial interfaces in Montor Overview, and you can configure them in "Configure", but Interface Status won't let you monitor traffic. You'd think this would be a common [sense] need.

Actions

This Discussion