vpdn-group configuration

dan.tesch · ‎06-26-2007

I am replacing a 2611 with a 2811, I am copying the setups from the old router, I have a question about the following.. on the old router there was no line in my config for l2tp - I do not seem to be able to find any configuration options for it - I don't nec want to get rid of it but want to mainly know how to config it and if the same options apply for pptp? I think I have gone into all of the listed options and put in "?" is l2tp missing from the help?

vpdn-group 1

! Default PPTP VPDN group

accept-dialin

protocol pptp

l2tp tunnel password 7

sbilgi · ‎07-02-2007

Which IOS version are you using? , if you are using lower version, need to upgrade to version 12.4(6)

Sample VPN group configuration:

vpdn-group 2

! Default L2TP VPDN group

description L2TP for Dial

accept-dialin

protocol l2tp

virtual-template 2

l2tp tunnel password xxxxx

dan.tesch · ‎07-02-2007

I am running 12.4(11). The commands for l2tp tunnel do not appear to be working, this is the kind of resp I get when attempting to use anything formatted with l2tp....

(config-vpdn)#l2tp tunnel password test

^

% Invalid input detected at '^' marker.