PIX 525 Boot Issues

Unanswered Question
Jun 26th, 2007
User Badges:

I have a 525 bundle but one of the firewalls will not boot up anymore. It gets to a certain point and then just hangs. These two firewalls were just recovered from a client site so I'm guessing at this point what may have happened. Is there a typical cause for this type of issue when the boot up just hangs? Below is all I see when consoled into the pix during boot up.


CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

256 MB RAM


PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

00 11 00 11D4 2F44 Unknown Device 11

00 13 00 1011 0026 PCI-to-PCI Bridge

01 00 00 8086 1229 Ethernet 11

01 01 00 8086 1229 Ethernet 10

01 02 00 8086 1229 Ethernet 9

01 03 00 8086 1229 Ethernet 5


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JBDanford2002 Tue, 06/26/2007 - 16:11
User Badges:

I would take it apart and reseat any cards. Also try replacing the CMOS battery. Can test with the working PIX parts.

Actions

This Discussion