Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
343
Views
0
Helpful
2
Replies

splitting an EtherChannel

cisco-pix
Level 1
Level 1

‎06-26-2007 12:45 PM - edited ‎03-05-2019 04:59 PM

Hi,

I have configured an EtherChannel to use PAgP over several fibre links from one site to another.

I have x2 1gig lines which I have EtherChanneled, I want to configure VLAN10 to take 75% of the bandwidth, and VLAN20 the remaining 25%.

How do I configure this?

Labels:
0 Helpful
2 Replies 2

sundar.palaniappan
Level 10
Level 10

‎06-26-2007 01:04 PM

AFAIK etherchannel doesn't support that sort of granularity in managing the flow of traffic in a direct way. Etherchannel supports load balancing based on individual or combination of MAC/IP/Port info. You might be able to influence the flow of traffic indirectly by choosing the right load balancing method by studying the physical interface stats.

http://cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a03.html#wp1020436

HTH

Sundar

0 Helpful

cisco-pix
Level 1
Level 1
In response to sundar.palaniappan

‎06-26-2007 01:44 PM

Is there any other way I can segment my connection in this way?

Or at least guaranttee a certain VLAN is given a fast connection, over the other VLANs on the trunk?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card