06-26-2007 01:14 PM - edited 03-05-2019 04:59 PM
This 1841 router has a WAN Interface
(WIC-1DSU-T1-V2), two embedded Fast Ethernet Interfaces, and a Four-port 10/100 Ethernet switch interface card.
My question is in regards to the 4-port switch. Is it in its own subnet, separate from the embedded ports?
To manage the switch would I have to connect via one of the 4 ports on the card, or could I connect via one of the embedded interfaces?
06-26-2007 01:19 PM
you can manage the switch either via the wan or the embedded ports.
If you configure a SVI, then you can manage it throught it as well.
above all console is always there :-)
Narayan
07-01-2007 02:37 PM
Should the devices connected to the 4ESW 4-port switch be configured for a subnet that is different than the embedded Ethernet ports?
How would I give an IP address to the 4ESW for management purposes?
07-01-2007 05:17 PM
Create an SVI and assign an ip address to that as you in any normal L3 switch
int vlan 1
ip address x.x.x.x y.y.y.y
no shut
HTH
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: