06-26-2007 03:45 PM - edited 03-03-2019 05:37 PM
Hi,
I have two cisco routers with tunnels between them.
The keep alive is 3 2 on both of them.
what should i do in order to have line protocol up
Thank you for your help
Solved! Go to Solution.
06-26-2007 04:01 PM
Correctly set tunnel source and destination and verify connectivity between said endpoints via:
ping
Hope this helps, please rate post if it does!
06-26-2007 04:01 PM
Correctly set tunnel source and destination and verify connectivity between said endpoints via:
ping
Hope this helps, please rate post if it does!
06-26-2007 05:43 PM
thanks for your reply.
It was my mistake with the access-list.
small mistake
case resolved
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: