Configuring Etherchannel in Catalyst Express 500 and servers

Unanswered Question
Jun 26th, 2007
User Badges:

I tried to connect a server with Portchannel (LACP a Catalyst Express 500, but it does not work. If the Catalyst Express is conected to the another switch by a Portchannel, it works OK, but, If a server with 2 ethernet interfaces in etherchanel is connected, it does not work. Do you know if this enviroment is supported?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
b.hsu Tue, 07/03/2007 - 06:11
User Badges:
  • Silver, 250 points or more

Catalyst Express 500 ports can be configured for SPAN only by using the Cisco Network Assistant (CNA). Complete these steps to configure the SPAN:

An EtherChannel is a group of two or more Fast Ethernet or Gigabit Ethernet switch ports bundled into a single logical link, creating a higher bandwidth link between two switches. The switch supports up to six EtherChannels.

For more information please click following URL:


This Discussion