CME4-Fallback and CCM 5.12

Answered Question
Jun 27th, 2007
User Badges:

Was looking for the min requirements for implementing CME-fallback on a ISR. Was thinking that I do not need to load any of the CME files (admin, html, phone loads...), just needed the telephony-service configuration. I just want to be able to use the enhanced features during fallback, but not CME itself.


I have looked at the CME4 admin/install guide as well as a Cisco provided CME4-fallback lab config guide and the two definitely do not match up on the requirements.


Thanks.

Correct Answer by Aaron Harrison about 10 years 3 weeks ago

Hi


You just need the configuration elements... not the GUI files/phone loads etc - last thing you want is phones to change firmware every time it fails to SRST.


Aaron


Please rate helpful posts...


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Aaron Harrison Wed, 06/27/2007 - 05:36
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


You just need the configuration elements... not the GUI files/phone loads etc - last thing you want is phones to change firmware every time it fails to SRST.


Aaron


Please rate helpful posts...


Actions

This Discussion