PIX 501 & 506 PDM Question

Unanswered Question
Jun 27th, 2007
User Badges:

Hello,

I have a question regarding the PIX 501 and 506e using PDM. When I first set up the device I am able to connect through PDM using the default settings, however when I change the internal IP interface and configure the laptop I?m using to utilize that network I am no longer able to connect using PDM. In order to gain access again, I have to unplug the firewall so it resets to factory settings. Thanks for any help in advance!


Greg

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Wed, 06/27/2007 - 09:36
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi Greg


Try adding to the config


http "your new IP address" 255.255.255.255 inside"


You need to allow your internal IP address to have access.


HTH


Jon

JORGE RODRIGUEZ Wed, 06/27/2007 - 09:42
User Badges:
  • Green, 3000 points or more

try


http 0.0.0.0 0.0.0.0 inside

telnet 0.0.0.0 0.0.0.0 inside


or per subnet


http 192.168.1.0 255.255.255.0 inside

telnet 192.168.1.0 255.255.255.0 inside




This way you are not bound to your IP only accesing the pix, you can now access it from any inside subnet.


HTH


Jorge



Actions

This Discussion