06-27-2007 09:23 AM - edited 03-05-2019 05:00 PM
Hello,
I have a question regarding the PIX 501 and 506e using PDM. When I first set up the device I am able to connect through PDM using the default settings, however when I change the internal IP interface and configure the laptop I?m using to utilize that network I am no longer able to connect using PDM. In order to gain access again, I have to unplug the firewall so it resets to factory settings. Thanks for any help in advance!
Greg
06-27-2007 09:36 AM
Hi Greg
Try adding to the config
http "your new IP address" 255.255.255.255 inside"
You need to allow your internal IP address to have access.
HTH
Jon
06-27-2007 09:42 AM
try
http 0.0.0.0 0.0.0.0 inside
telnet 0.0.0.0 0.0.0.0 inside
or per subnet
http 192.168.1.0 255.255.255.0 inside
telnet 192.168.1.0 255.255.255.0 inside
This way you are not bound to your IP only accesing the pix, you can now access it from any inside subnet.
HTH
Jorge
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: