Configuring direct lines for managers on FXO cards

Answered Question
Jun 28th, 2007

Hi all

I have this configuration below in a cisco 2801 router running CCME. I have configured connection Plar directing external calls to specific extensions. I have a problem with ensuring that outbound calls from a manager on extension 203 are always routed to voice port 0/0/0 and that all other outbound calls from other users don't ever use this voice port 0/0/0. The main aim is having a fixed/direct line for manager on extension 203.

voice-port 0/0/0

dial-type pulse

no non-linear

cptone GB

connection plar opx 203

impedance complex2

caller-id enable

!

voice-port 0/0/1

dial-type pulse

no non-linear

cptone GB

connection plar opx 206

impedance complex2

caller-id enable

!

voice-port 0/0/2

dial-type pulse

no non-linear

cptone GB

connection plar opx 208

impedance complex2

caller-id enable

!

voice-port 0/0/3

dial-type pulse

no non-linear

cptone GB

connection plar opx 207

impedance complex2

caller-id enable

!

dial-peer voice 1 pots

preference 2

destination-pattern 9T

port 0/0/0

!

dial-peer voice 2 pots

destination-pattern 9T

port 0/0/1

!

dial-peer voice 3 pots

preference 1

destination-pattern 9T

port 0/0/2

!

dial-peer voice 4 pots

destination-pattern 9T

port 0/0/3

dial-peer voice 203 voip

destination-pattern 203

session target ipv4:192.168.42.1

dtmf-relay h245-signal

codec g711ulaw

!

dial-peer voice 206 voip

destination-pattern 206

session target ipv4:192.168.42.1

dtmf-relay h245-signal

codec g711ulaw

!

dial-peer voice 208 voip

destination-pattern 208

session target ipv4:192.168.42.1

dtmf-relay h245-signal

codec g711ulaw

!

dial-peer voice 207 voip

destination-pattern 207

session target ipv4:192.168.42.1

dtmf-relay h245-signal

codec g711ulaw

Regards

Sollo

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 9 years 5 months ago
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion