HWIC-1FE in a 2851 Router not coming up

Unanswered Question
Jun 28th, 2007

I have installed an HWIC-1FE in a 2851 router and when I boot up the device, the new interface does not show up. Only the 2 Gigabit interfaces which are on-board come up? I have verified they are in the proper slot and even tried moving them to a different slot. When I do a show ip int brief, it is not there. Is there a command to enable the interface? Has anybody come across this before? Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mark.blanchfield Thu, 06/28/2007 - 13:03

I have resolved the issue. An IOS upgrade was required.

Note: For the HWIC-1FE and HWIC-2FE the minimum level is Cisco IOS 12.4(11) XJ.

Actions

This Discussion