06-29-2007 01:27 AM
Hi
I have a PIX 515E Firewall at my central office.
I use cisco VPN clinet to connect the same from remote sites.so far i am able to connect to it.
but i have some other branches connected to the central location over MPLS which dont have firewall.
My problem is I my struglling with a solution to connect to the branch network using the cisco VPN client.
Is there any solution how I can do this without using the remote desktop.
Like can I connect my branch network through the VPN tunnel which is upto my central location.
06-29-2007 10:06 AM
My understanding is that you would like to connect two offices together using current internet connections.
In my oppinion, it is best to put another firewall at your branch/s and setup a firewall to firewall VPN.
Did this help?
07-05-2007 01:13 AM
Thank you for the reply
But at this moment I dont have firewall for the branches.
07-03-2007 05:27 AM
I'm assuming that the remote sites connected via MPLS are on different subnets.
If that the case, you will need to add the remote sites encryption domains into the PIX config for the VPN clients.
Make sure the routing on the PIX is corrent too.
07-04-2007 07:17 AM
Hi,
Just curious about why you are not able to reach PIX via ciso VPN client?.
Are you expecting support for installation/configuration of cisco vpn client in your remote site PC?
--Jaffer
07-05-2007 01:18 AM
Yes support for configuration on firewall would be really helpful.
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: