QOS on a 7600

Unanswered Question
Jun 29th, 2007

I am looking at this customer config to be applied to a 1GE interface (1p3q8t)

isn't Q to COS mapping inccorect. I would expect to see different COS spread out accross the Qs.

wrr-queue cos-map 3 1 3

wrr-queue cos-map 3 2 4

wrr-queue cos-map 3 3 6 7

secondly, what is the point using wrr-threshold and

wrr-queue random-detect max-threshold & wrr-queue random-detect min-threshold at same time. I would have expected to use either tail drop threshold or WRED drop threshold not both.

wrr-queue threshold 2 100 100 100 100 100 100 100 100

wrr-queue random-detect min-threshold 1 40 70 100 100 100 100 100 100

wrr-queue random-detect min-threshold 2 70 100 100 100 100 100 100 100

wrr-queue random-detect min-threshold 3 70 100 70 100 100 100 100 100

wrr-queue random-detect max-threshold 2 100 100 100 100 100 100 100 100

below link is not clear on the use of this command.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/cmdref/w1.htm#wp1022990

any feed back would be appreciated.

Sam

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion