Regarding error in Cisco 2811 router

Unanswered Question
Jun 30th, 2007
User Badges:

hi


Can anyone tell me abt this error while inserting NME-16ES-1G-P=Etherswitch in 2811 router .


error :% Shuting down Internal GE interface GigabitEthernet1/0 may render inline power for EtherSwitch Service Module not working properly

SETUP: new interface GigabitEthernet1/0 placed in "shutdown" state


Kindly revert back to me.


Rgds

Senthil

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
b.hsu Fri, 07/06/2007 - 06:12
User Badges:
  • Silver, 250 points or more

NM-16ESW-PWR-1GIG is an EtherSwitch network module with Power over Ethernet (PoE) capabilities. After you add this card, you might not be able to configure PoE. This is because you need to have a matching power supply installed on the router to support the PoE features. For more information please click following URL:

http://www.cisco.com/en/US/products/ps5854/products_tech_note09186a008073dc12.shtml#nm1


n.sebastian Tue, 05/05/2009 - 08:13
User Badges:

I do have the same problem and non of my ethernet ports do come up. My router is a 2821 and with the IP power supply

Leo Laohoo Tue, 05/05/2009 - 13:47
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

When you insert this NME into the router, by default the "backplane", Gi1/0, is DISABLED.


Give Gi1/0 an IP Address and "no shutdown" and you should be OK.


Hope this helps.

Actions

This Discussion