access port

Unanswered Question
Jul 1st, 2007

Here is the senario...

there are 2 access layer switch 1&2 they are connected using access link,on switch1 i have all ports in vlan2 and on switch2 i have all the ports in vlan 10.

will i be able to ping from a system connected to switch1 to system on switch2 the system are in same subnet.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mohammedmahmoud Sun, 07/01/2007 - 02:46

Hi,

Although this is a weired setup, but it should work, as the frames are sent untagged on access ports.

HTH,

Mohammed Mahmoud.

vishwancc Mon, 07/02/2007 - 00:32

thanks for the reply..

One more doubt with the access port on both side show up or flap,since they belong to different vlan

mohammedmahmoud Mon, 07/02/2007 - 00:51

Hi,

As i told you before although this is a weired setup as it makes no sense to connect 2 switches via access ports, they should be connected via trunk ports (in order to be able to handle all the VLANs between the 2 switches), but it should work as the frames are sent untagged on access ports and this shouldn't have any impact on the ports.

HTH,

Mohammed Mahmoud.

Actions

This Discussion