07-01-2007 02:05 PM - edited 03-03-2019 05:41 PM
I am looking for a way to change the admin distance and or hop count on routes learned via RIP. However, the tricky part is that I want to change a route for a certain subnet ONLY if it comes from a specific router but not all routes from that router. For instance, if I learn of subnet 1.1.1.0/24 from router A I would like it to have the default admin distance of 120. However if I get a 1.1.1.0/24 from router B then I want it to get an admin distance of say, 130 but keep all other subnets from router B to be the standard 120 distance. Is this possible?
Thanks,
Diego
07-01-2007 03:06 PM
I don't think what you want is possible.
The mechanism that would allow you to match an update source (route map with match ip route-source), is allowed only when redistributing in a different protocol.
And the offset-list and distance commands, let you specify subnets via ACL, not update sources.
Hope this helps, please rate post if it does!
07-01-2007 03:38 PM
Let's say Router B source address is 192.168.1.3
On the router receiving this route configure the following:
ip access-list standard RIP
permit 1.1.1.0 0.0.0.255
router rip
distance 130 192.168.1.3 0.0.0.0 RIP
07-01-2007 03:40 PM
Very good, this syntax for distance has completely escaped me. And I looked at it for while...
07-03-2007 06:18 AM
I will be trying this over the holiday. It does look promising.....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: