Dynamic Interfaces w/Multiple WLC's & SSID's/VLAN's

Unanswered Question
Jul 1st, 2007

The setup I'm working on will use 3-WLC's with 6 user SSID's. The deployment guide and config guide state that I should configure a dynamic interface for each VLAN and assign an IP address, then assign each SSID to their respect VLAN.


Does a virtual interface assigned to a corresponding VLAN on different controllers get assigned a different IP address?


WLC-A -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.1

WLC-B -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.2

WLC-C -->SSID:Faculty1-->VLAN 10-->>IP: 10.0.0.3

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rupert.wever Sun, 07/01/2007 - 23:47

Your dynamic interfaces look good.

All controllers should have the same virtual IP addresses, typically 1.1.1.1 - this is used more for inter-controller mobility.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode